Description
Magnetic angular transducer embedded microprocessor is combined with the CNC angular second calibration device to achieve the high precision measurement of 0.1° or 0.3° by programmed calibration and conversion.
Specification
| Model | ATO-LW120A | ATO-HW220A |
| Full Range Precision | ±0.3° | ±0.1° |
| Temperature Drift | ±0.01°/°C | ±0.02°/°C |
| Measuring Range | 0~30°, 0~60°, 0~90°, 0~180°, 0~270°, 0~360° (Optional) | |
| Output Signal | 0-5V, 0-10V (Optional) | |
| Output Load | 2kΩ | |
| Voltage Input | 9-36V DC | |
| Typical Voltage | 12V | |
| Sampling Frequency | 1KHz | |
| Linearity | 0.5%~0.15% | |
| High Vibration Resistance | >20000g | |
| Frequency Response | 100Hz | |
| Angle Resolution | 0.022° | |
| Full Range Accuracy | ±0.3° | |
| Operating Temperature | -40°C~+85°C | |
| Storage Temperature | -55°C~+100°C | |
| Power-on Startup Time | 0.2s | |
| Response Time | 0.01s | |
| Average Operation Time | ≥55000 Hour/Time | |
| Cable | with 1.5m length shielded cable 3*0.3mm2 | |
| Power Reverse Protection | 40mV | |
| Signal Reverse Protection | 40mV | |
| Running Torque | <10mN·m | |
| Material | Shell: Aluminum alloy oxidation Back Cover: Stainless steel Shaft: Stainless steel |
|
| Protection Grade | IP66 | |
| Weight | 1kg |
Dimensions (Unit: mm)
Wiring Diagram
| Red | Black | Yellow |
| 1 | 2 | 3 |
| VCC (Power Positive) | GND (Power Negative) | Signal Cable |
Installation Methods
Angle Measuring Chart
Applications
Tips: What is angle sensor?
Angle sensor refers to an angular transducer that can sense the measured angle and convert it into a usable output signal. Angle sensors, as the name suggests, are used to detect angles. There is a hole in its body to fit the Lego shaft. When connected to the RCX, the angle sensor counts every 1/16 revolution of the shaft. When rotating in one direction, the count increases, and when the rotating direction changes, the count decreases. The count is related to the initial position of the angle sensor. When initializing the angle sensor, its count value is set to 0, if necessary, you can reset it by programming. The position and speed can be easily measured by calculating the angle of rotation.
Reviews
There are no reviews yet.