Description
Digital counter has 4 digit display, frequency/rev/linear speed measuring function, DC 12V/24V external power supply.
Features:
- Various parameter settings, simple operation.
- Input: Various waveform pulses (square wave, triangle wave), proximity sensor, photoelectric sensor, voltage signal, contact switch, encoder, etc.
- Digital counter can also be used to measure the power frequency (AC 0-600V), measurement range: 0.01Hz-100KHz, resolution: 0.01Hz.
- 4 digit display, decimal point automatic conversion.
- Input/output signals photoelectric isolated, anti-interference ability.
- Digital output: Up to 3 alarms, high value, low value, high and low value alarm modes are optional, analog output: 4-20mA or 0-10V transmission output, measuring range setting arbitrarily.
- Standard RS232 or RS485 MODBUS RTU communication, can be directly connected with computers, PLC or other equipments.
Specification:
| Mode | ATO-DIGC-FA4 |
| Weight | 300g |
| Accuracy | 0.1%±2 digit |
| Power supply | AC 220V/110V±15%, AC 90-260V, DC 24V±10%, power dissipation≤5VA |
| Input signal | Pulse signal, square wave, sine wave, 5V≤H≤30V, 0≤L≤2V, rising edge trigger, frequency: 0.01~10KHz, 1Hz-100KHz |
| Display counting range | -1999~9999 |
| Input impedance | ≥10KΩ |
| Transmission output | 4-20mA, 0-10V, etc. (range can be set) |
| Insulation resistance | ≥100MΩ (between DC 500V power terminal and external terminal) |
| Dielectric strength | AC 1500V 1min (between power terminal and external terminal) |
| Environment | Ambient temperature: 0~50°C, relative humidity: 35~85%RH |
| External power supply | DC 12V±5%, 50mA max / DC 24V±5%, 30mA max |
| Protection class | IP65 |
Selection table:
| Dimension (length*height*depth) | Power supply | AL1 | AL2 | Communication interface | External power supply |
| 4: 48*48*80mm with hole size 45*45mm; 9: 96*96*80mm with hole size 92*92mm |
V0: AC 90-260V; VE: AC/DC 12-30V, or DC 24V |
N: No output; R: Relay; S: SSR/LOGIC |
N: No output; R: Relay; S: SSR/LOGIC |
C0: No communication; C2: RS232; C4: RS485 |
A: DC 12V/30mA; B: DC 24V/30mA; C: DC 5V |
Wiring diagram:
Tips: Digital counter application in digital system
Counter is typical sequential logic circuit and also is the most used sequential logic devices in digital systems. Using a digital counter to count pulses or conduct fractional frequency can achieve measurement, calculation, timing control and other functions. In addition to the counting function, the counter also has functions such as asynchronous reset, preset parameter, and hold. The preset function is divided into two kinds: synchronous preset and asynchronous preset. The former is controlled by timing pulses, and the later is not controlled by timing pulses. The hold function is also divided into two types: hold-carry and hold without carry. The counter can also be used as a sequential pulse generator.
Reviews
There are no reviews yet.